Force JX-DS925 - Assembly Instructions; Initial Frame and Weight Stack Setup (Steps 1-8)

Assembly Instructions
Insert 2 pcs guide rods (18#) into the holes of the Rear Stabilizer(4#) separately and secure them with 2
pcs M10*20 Allen Bolt(63#) and 2pcs
φ
10 washers(69#).Slide the 2pcs rubber bumper(48#) along the
guide rods separately.
Attach the Base Frame(1#) to the Rear Stabilizer(4#) as the diagram shows and secure them with 2pcs
M10*70 carriage bolt(58#),1pc bracket(29#),2pcs
φ
10 washers(69#) and 2pcs M10 Aircraft nuts(68#) .
Step 1
5