ForceDoor BASE 35 - Page 14

12
Press SET to enter, digital flashing
display ；Use the UP or DOWN
buttons to adjust the number displayed on
the digital tube between
... to . Select the
target parameter, press SET to confirm the
function option, then exit to the menu
，Continue to set the next function
menu, or press the cancel button to exit
the function setting.
Remark:
Default
a. Select to , which
means the limit position moves
further in the OPEN DOOR direction.
b. Select to , which
means the limit position moves in the
door center direction.
 Press and hold SET button for
about 6 seconds to enter main
menu until “0.-” appears on the
display then release the button.
 Press UP till “1.-” appears on the
display.
 Press SET then “1.0” appears on
the display.
 Press UP till “1.3” appears on the
display,
Press SET to enter, digital flashing
display ; Use the UP/DOWN
buttons to adjust the number displayed on
the digital display between
... to . Select the
target parameter, press SET to confirm the
function option, then exit to the menu
.
Fine adjustment of the close
limit position
[Press UP from (1.2)]