Press and hold SET button for
about 6 seconds to enter main
menu until “0.-” appears on the
display then release the button.
Press UP till “5.-” appears on
the display.
Press SET into the Infrared
Beam & Light Curtain function
Press SET to enter, the digital
displays （default）；
Adjust the stalls from
to , by buttons
UP/DOWN.
means:The infrared interface
function is disabled.
means:The infrared function
interface is enabled.
means:The built-in infrared beam
identification function (Built-in light
curtain identification function) is enabled.
Select function（default），Press
SET to save and exit the function menu.
Select function，which means the
infrared beam function is enabled. Then
after pressing the SET button to save
setting, the digital displays
immediately after this operation,which
means entering the coordination setting of
infrared function and Auto-close
function.
To Next Page
Loading...