Adjust the stalls from to
by buttons +/-.
means: The infrared function is
not related to the AUTO CLOSE function.
means: The AUTO CLOSE
function must be enabled after the infrared
function is turned on.
After selecting, press SET to save the
setting and exit the function setting.
Important Notice:
Only the Normal-Close (NC) contact is
compatible with the “PE” port terminal.
2. Make sure the Infrared Beam /Light
Curtain has been correctly installed,
otherwise the door will be allowed for
opening but not closing. The digital
displays faulty .
Important Notes:
Pre-Installed and tested (Refer to the
menu “5.1”) the built-in Infrared Beam
/Light Curtain to ensure it ’ s correct
performance before select the menu .
Select function，enter into
the menu of built-in Infrared Beam
/Light Curtain identification setting.
The display shows ,which
means the original travel limits
should be re-set.
Refer to the menu , or refer
the quick setting guide by “AAS”
（Automatic adapt system）to reset
the travel limit.
Remark: The built-in infrared Beam
/Light Curtain will be identified
Built-in Infrared Beam /Light
Curtain identification setting
To Next Page
Loading...