ForceDoor BASE 35 - Page 23

21
menu, digital quickly display
，Then it flashes ，
 Adjust the stalls from to
by buttons +/-. （ 9
stalls represent 10%-90% of the
door travel limit）
 Press SET to confirm and exit to
the menu .
You can continue to set the next function
menu. Or press the RETURN button to exit
the function setting.
Remark:
(default).
It means that the partial open door
position is 50% of the full travel limit.
 Press and hold SET button for
about 6 seconds to enter main
menu until “0.-” appears on the
display then release the button.
 Press UP till “6.-” appears on
the display.
 Press SET then appears “6.0” on
the display
 Press UP till “6.2” appears on the
display.
 Press SET enter into the PB Port
function setting.
Execute OPEN-STOP-CLOSE the
door action.Single-cycle function
(default)
 Execute CLOSE the door action
ONLY at the open limit position.
 Execute OPEN the door action ONLY
at the close limit position.
 Door opening action will be
executed at any position other than
the close/open limit position
PB Port function setting (NO)