ForceDoor BASE 35 - Page 28

26
MENU7 Courtesy Light Function Setting
 Press and hold SET button for about
6 seconds to enter main menu until
“0.-” appears on the display then
release the button.
 Press UP till “7.-” appears on the
display.
 Press SET into Courtesy light off
delay time setting.
 Press SET to enter the function
menu, digital tube display .
 Adjust the stalls from to
by buttons UP/DOWN.
default，means 3 minutes delay.
1 minute per stall. It is adjustable for 1-9
minutes. Select the delay time of the
courtesy light, press the SET button to save
setting,At the same time, enter the warning
function setting of the courtesy light，
digital tube display ，Adjust the stalls
from to by buttons
UP/DOWN.
means the courtesy light operation
warning function is off.
to means:The corresponding
warning 1-9 second time selection,1-9
second option means flashing before door
drive starts running.
Remark：
a. After the door drive stops running, the
courtesy light delay time can be
adjusted from 1 ～ 9 minutes, the
default is ，means 3 minutes off
delay.
b. After the courtesy light warning
Courtesy light off delay time setting