function is turned on, the courtesy light
will flash for a corresponding time
before the door drive runs each time,
and then the door drive will start to
perform actions.
MENU8 Maintenance Alarm Function Setting
Press and hold SET button for about
6 seconds to enter main menu until
“0.-” appears on the display then
release the button.
Press UP till “8.-” appears on the
display.Press SET then “ 8.0 ”
appears on the display.
Press SET to enter the Maintenance
alarm cycle-counting setting.
Indicates that the maintenance
alarm function is closed (factory default)
Press SET to enter the function menu,
digital displays (factory
default).
Adjust the stalls from to
then by buttons
UP/DOWN.
500 cycles per stall.
Cycles-calculation method is 500*N,
N=01—15. A=10；F=15
e.g.
means：1*500=500 cycles；
means：2*500=1000 cycles；
means：10*500=5000 cycles；
means：15*500=7500 cycles
Maintenance alarm
cycle-counting setting
To Next Page
Loading...