ForceDoor BASE 35 - Page 30

28
 Press and hold SET button for about
6 seconds to enter main menu until
“0.-” appears on the display then
release the button.
 Press UP till “8.-” appears on the
display.Press SET then “ 8.0 ”
appears on the display.
 Press UP till “8.1” appears on the
display , Press SET to enter the
Query the remaining cycles of
maintenance alarm
Press SET to enter the function query,
the digital will circulated display
, then after
the cumulative loop display 3 times, the
query display will exit.
Remark:
a. Running cycles counter will not be
cleared even after the door drive is
restored to factory settings.
b. Maintenance alarm description
(Running cycles will minus 1
cycle, after the door drive reaching
the close limit position each time)
c. When the maintenance alarm count
shows 0, when the door drive runs
to the open and close limit
positions each time, the courtesy
light will flash quickly, the buzzer
will sound continuously to remind
the customer that the door and the
drive unit need maintenance, and
the digital tube will display fault
.
d. After the maintenance of the door
or drive unit is completed, the
maintenance personnel need to
re-enter the menu to set the
maintenance alarm cycles, and the
cycles of maintenance alarms will
restart to count.
Query the remaining cycles
of maintenance alarm