Forcepoint Next Generation Firewall Hardware Guide | Models 330, 331, 335, 335W
4) Wait until the power indicator light turns red or is unlit, then unplug all power cables from the appliance.
Replace the CFast card
Replace the CFast card with another card that you received from Forcepoint.
Note: We recommend fastening a grounding strap to your wrist so that it contacts your bare skin
and attaching the other end of the strap to the appliance.
Steps
1) Turn off the appliance and disconnect any power cables.
2) Locate the CFast card on your appliance.
3) If there is still tape covering the CFast card, remove the tape.
4) Gently push in the CFast card to release the card from the slot.
5) Position the replacement CFast card. Turn the end with the slots toward the appliance. The wider slot must
be on the left.
6) Insert the new CFast card into the slot and gently push to lock the card into place.
7) Reconfigure the appliance for the replacement CFast card. See the initial configuration information in the
Forcepoint Next Generation Firewall Installation Guide.
Replace an interface module
Replace an interface module with the same type or a different type of module.
If the appliance was delivered with a plate that covered the interface slot, you can alternatively cover the interface
slot with the plate instead of replacing the interface module with another module.
Note: We recommend fastening a grounding strap to your wrist so that it contacts your bare skin
and attaching the other end of the strap to the appliance.
Steps
1) Turn off the appliance and disconnect any power cables.
2) To release the module, unscrew the thumbscrews, then carefully pull the module out of the slot.
3) Insert the new module.
4) Push and hold the thumbscrews on the module, then tighten them to secure the module in place.
17
To Next Page
Loading...
