Forcepoint 330 Series - Remove SFP transceivers; Compliance information

Forcepoint Next Generation Firewall Hardware Guide | Models 330, 331, 335, 335W
Steps
1) Turn off the appliance.
2) Remove the interface module from the interface module slot.
3) Locate the tab at the lower left corner of the plate.
4) Insert the tab into the hole in the lower left corner of the slot casing.
5) Slide the plate inward until it covers the slot and the thumbscrew in the plate aligns with the screw hole to the
right of the slot.
6) Push and hold the thumbscrews on the plate, then tighten them to secure the plate in place.
Remove SFP transceivers
You can remove or replace SFP transceivers.
CAUTION: Invisible laser radiation is emitted from the end of a fiber-optic cable and from the fiber
port. Do not stare into the beam and avoid direct exposure to the beam.
Note: We recommend fastening a grounding strap to your wrist so that it contacts your bare skin
and attaching the other end of the strap to the appliance.
Steps
1) Turn off the appliance and disconnect any power cables.
2) Unplug all power cables from the system or the wall outlets.
3) Disconnect the cable from the SFP transceiver.
4) Pull down the latch on the transceiver, then carefully pull the SFP transceiver out of the port slot.
5) If needed, insert a replacement SFP transceiver in the slot.
Compliance information
Forcepoint NGFW appliances that have wireless support are in compliance with certain EU directives and FCC
standards for wireless devices intended for home and office use.
This information is valid for all dual band products (2.4 GHz, IEEE 802.11b/g/n, and 5 GHz, IEEE 802.11a/n/ac).
The supported channels and frequencies are listed by country in the Management Client. The wireless
configuration is transferred to the appliance when you install the policy on the NGFW Engine.
19