ProCal 3
Instructions
NO PART OF THIS DOCUMENT MAY BE REPRODUCED WITHOUT PRIOR AGREEMENT AND WRITTEN PERMISSION OF
FORD PERFORMANCE PARTS.
Questions? http://bit.ly/1KdPDjy or (800) FORD788
Factory Ford shop manuals are available from Helm Publications, 1-800-782-4356
Page 6 of 14
f. Configuration Tab
•
••
• Octane Adjust – Switch to “ON” if spark retardation is desired
•
••
• Profile Learning – Switching to “ON” initiates a misfire monitoring relearning sequence
•
••
• Axle Ratio – ratio of driveshaft revolutions per minute to rear axle revolutions per minute
•
••
• Tire Size – The number of tire rotations per mile. This information should be available from the tire
manufacturer.
!!! SUBSEQUENT STEPS REQUIRE AN INTERNET CONNECTION IN ORDER TO COMPLETE THE
INSTALLATION OF YOUR PERFORMANCE CALIBRATION ONTO YOUR VEHICLE’S PCM; IF YOUR VEHICLE IS
LOCATED SOMEWHERE WITHOUT AN INTERNET CONNECTION, PLEASE COMPLETE THE CALIBRATION
DOWNLAD BEFORE LEAVING THE INTERNET CONNECTED AREA !!!
To Next Page
Loading...
