16. Loosen cylinder No. 3 intake valve rocker arm bolt and rotate rocker arm (6564) off push rod (6565)
and away from top of valve stem. Remove push rod.
NOTE: Intake manifold (9424) may be removed with fuel injector and fuel injection supply manifolds
(9F792) in place.
17. Remove intake manifold retaining bolts using a Torx® head socket. Before attempting to remove
intake manifold, break the seal between the intake manifold and cylinder blocks (6010). Wedge a
large screwdriver or similar heavy-duty tool between the manifold and the block. Pry upward on the
tool using the lug on top of the front cover as a leverage point. Removal of generator (GEN) (10300)
may be required for this step. Use care to prevent damage to machined surfaces.
Fuel Rail and Injectors to Intake Manifold, Installation
Item Part Number Description
1 — Outlet End (Part of 9F593)
2 9F593 Fuel Injector
3 — Inlet End (Part of 9F593)
4 — Black Shipping Cap
(Part of 9F593)
5 — Green Shipping Cap
(Part of 9F593)
6 N802353-S100 Bolt
7 9F792 Fuel Injection Supply Manifold
8 9424 Intake Manifold
A — Tighten to 8-12 Nm
(71-106 Lb-In)
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B17.HTM~gen~ref.HTM
To Next Page
Loading...
Need help?
General
