Ford 1997 Ranger - Crankshaft Pulley, Vibration Damper, and Front Seal; Crankshaft Front Seal Removal; Crankshaft Front Seal Installation

IN-VEHICLE SERVICE
Crankshaft Pulley/Vibration Damper/Crankshaft Front Seal
Removal
1. Disconnect ground cable at battery and set aside.
2. Remove air cleaner outlet tube assembly.
3. Remove drive belts.
4. Remove four pulley-to-damper retaining bolts.
5. Remove crankshaft pulley (6312).
6. Remove crankshaft vibration damper bolt and crankshaft vibration damper washer.
7. Remove crankshaft vibration damper from crankshaft (6303) using Crankshaft Damper Remover
T58P-6316-D and Vibration Damper Remover Adapter T82L-6316-B.
8. Pry crankshaft front seal (6700) from engine front cover (6019) with a flat-bladed screwdriver or other
similar tool. Use care to prevent damage to engine front cover and crankshaft.
Section 03-01B: Engine, 3.0L V-6 1997 Aerostar, Ranger Workshop Manual
SPECIAL SERVICE TOOL(S) REQUIRED
Description Tool Number
Front Cover Seal Replacer T70P-6B070-
A
Crankshaft Damper Remover T58P-6316-D
Vibration Damper Remover Adapter T82L-6316-B
Vibration Damper and Seal Replacer
T82L-6316-A
Page
1
of
3
1997 Aerostar/Ranger
2011
-
04
-
27
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B19.HTM~gen~ref.HTM
tomsn048@gmail.com