Ford 1997 Ranger - Cylinder Block, Bare; Cylinder Block Disassembly; Cylinder Block Assembly

DISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIES
Cylinder Block, Bare
Before replacing a cylinder blocks (6010), determine if it is serviceable. If so, make the necessary service.
Refer to Section 03-00 .
D
isassembly
1. Completely disassemble the used engine, following the procedures in Removal and Installation .
2. Remember to ridge ream the cylinder bores before removing pistons (6108).
3. Remove the cylinder head to block dowels (6A008) and the cylinder block drain plugs.
Assembly
1. Clean the gasket and seal surfaces of all serviceable parts and assemblies.
2. Position the new cylinder blocks in a work stand and install the cylinder head to block dowels and the
cylinder block drain plugs.
3. Transfer all serviceable parts removed from the used cylinder blocks, following the procedures in
Removal and Installation
.
4. Check all assembly clearances and correct as necessary.
Section 03-01B: Engine, 3.0L V-6 1997 Aerostar, Ranger Workshop Manual
Page
1
of
1
1997 Aerostar/Ranger
2011
-
04
-
27
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B48.HTM~gen~ref.HTM
tomsn048@gmail.com