Ford 1997 Ranger - Cylinder Block Assembly; Cylinder Block Disassembly

DISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIES
Cylinder Block Assembly
Disassembly
1. Mount the engine (6007) in a work stand and remove all parts not furnished with the new cylinder
blocks (6010), following the procedures in Removal and Installation
.
2. Remove the four cylinder head to block dowels (6A008) and the cylinder block drain plugs.
3. Remove the used cylinder blocks from the work stand.
Assembly
1. Clean the gasket and seal surfaces of all serviceable parts and assemblies.
2. Position the new cylinder blocks in a work stand and install the cylinder head to block dowels and
block cylinder drain plugs.
3. Transfer all serviceable parts removed from the used cylinder blocks, following the procedures in
Removal and Installation .
4. Check all assembly clearances and correct as necessary.
Section 03-01B: Engine, 3.0L V-6 1997 Aerostar, Ranger Workshop Manual
Page
1
of
1
1997 Aerostar/Ranger
2011
-
04
-
27
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B47.HTM~gen~ref.HTM
tomsn048@gmail.com