6. Reinstall engine accessory drive belt tensioner and torque to 35-45 Nm (27-33 lb-ft).
7. On Ranger only, install A/C compressor to steering pump support bracket with 3 bolts and torque to
22-28 Nm (17-21 lb-ft).
8. Reconnect bypass hose to fitting on intake manifold and tighten clamp.
9. Install heater water return hose at water pump fitting and tighten clamp.
10. On Aerostar only, if equipped with auxiliary heater, reinstall auxiliary heater tube bracket at power
steering pump support bracket and torque to 8-12 Nm (6-8 lb-ft).
11. Connect crank position sensor (CKP) wiring at sensor.
12. Reinstall generator and bracket assembly to right cylinder head with 3 bolts and torque to 40-54 Nm
(30-40 lb-ft).
Front End Accessory Drive, Upper — Aerostar
13 N602098-S2 Screw and Washer
14 8509 Water Pump Pulley
15 6312 Crankshaft Pulley
A — Tighten to 40-55 Nm
(30-41 Lb-Ft)
B — Tighten to 53-72 Nm
(39-53 Lb-Ft)
C — Tighten to 21-29 Nm
(16-21 Lb-Ft)
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B20.HTM~gen~ref.HTM
To Next Page
Loading...
