Ford 2000 - EVERY 50 HOURS

SECTION
F
SERVICING
SCHEDULE
EVERY
50 HOURS
(Figures
F6—F12)
F6. Air
Cleaner
(Oil Bath
Type)
Drain the
oil and
clean
both cups.
Refill the
cups with
oil to
the proper
level Do
not overfill
Remove
any dirt
from
the mesh
screen
element
in the
base of
the
air
cleaner body.
F7.
Battery
Clean
the
top of the
battery,
check the
electrolyte
level and,
if necessary,
add
distilled water
to bring
the level 0-25
inch
(6
mm)
above
the top of
the separators
Do not
use an
exposed flame
for
checking
the electrolyte
level.
F8.
Fuel
Filters
Open the
drain
plug on the rear
filter
(where fitted)
and
drain any
accumulation
of
water. Close
the drain
plug and
repeat
the operation
on
the front filter Carry
out
at more frequent
intervals
where high
condensation
is
present.
F9.
Grease Fittings
Wipe
away all
old grease
and dirt
from
the following
fittings
and
apply
good
quality grease,
using
a high
pressure
gun, until
all the
old grease
has
been
expelled.
Wipe off
surplus grease.
(a) Front
wheel
spindles,
(b) Handbrake
cross
shaft and
lever
extension
tube
(3 fittings—
rearwheel
handbrake—
Ford
2000
and 3000
only).
(c) Brake
pedal pivots.
(d) Cluich
pedal pivots.
(e) Hydraulic
lift linkage
rods
and
levelling
box.
(f)
Power
assisted steering
cylinder
supports (Ford
2000/3000/4000
only).
(g)
Differential
lock redal
support.
(Ford
2000/3000/4000
only),
(h) Automatic
Pick-up
Hitch
Spindles
(Ford
2000
and 3000
only).
(i)
Front axle
Trunnion
Pin,
(Vineyard
only).
(j)
Steering
Centre
Pivot (Ford
5000
Power
assisted
steering only).
(k) Automatic
pick-up
hitch locking
latch
(Ford 4000
and
5000 only).
•i
1