Ford 2000 - TRANSMISSION P.T.O.

.:
POWER
TAKE-OFF OPERATION
SECTION
C
'
I
l
M
POWER TAKE-OFF SHAFT
Your Ford tractoris equipped with a
1-375
inch
(34-9 mm) diameter PTO shaft.
The standard PTO speed is 540
t
1
rpm and most PTO
implements willoperate
at
maximum efficiency
when the PTO is operated within this speed
range.
:
TRANSMISSION P.T.O. (Figure C1)
The
Transmission' type of
PTO (available on Ford 2000, 3000 and 4000
tractors) is operated by
engaging the clutch, and
will stop turning when the
clutch pedal
(1)
is depressed.
The
drive
to
the PTO is engaged by
depressing the clutch pedal and moving the
PTO
lever
situated
on the left-hand side of the
rear transmission, fully rear-
wards
(2).
To disengage
the PTO depress the clutch and
move the lever to the
forward position
(3).
The table
below shows the recommended
engine
speeds
to obtain the PTO
speed of 5404; 10 rpm.
Transmission
6/7 speed
8 speed
8 speed
V.o.ih
Ford 2/3000
Ford 2/3O0O
Ford 4000
Engine Speed
(rpm)
1800
1600
1800