Ford 2000 - POWER ADJUSTED REAR WHEELS

OPTIONS AND ACCESSORIES
SECTION H
Optfdlion:
1'ulling the lever(s) rearward will raise the equipmenl
and
pushing
the lever(s)
lurwiud will
lower the
equipment.
Valves with detents hold the levor(s)
in
josition
until
the external cylinder reaches the end of its stroke
when the lever
(s) will automatically return to neutral.
On
valves without detents the levers will spring
back to
neutral
immediately
limy nro released.
With
remote control
valves both single-acting or double-acting cylinders may
l»>
operated in various
combinations.
Consult your authorised Ford
Tractor
Dualcr lor Full details, for advice on fitting, operating procedures and the
many
vices which can be provided by these valves.
WHEELS
OWfcR ADJUSTED REAR WHEELS
I
'(
iwer adjusted rear wheels are available for
use
with
1
2*4/1
1
•
28 tyres on the
I
Ofd
2000 and
3000, and
13-6/12 -.38
tyres on the Ford 4000 and 5000.
Rtir
wheel track can
be
easily
adjusted in 4 inch
(10*2
cm) steps
over two
width ranges.
M»'
ranges are as follows:
Full range
12/3000 52-80
inches
(132-1
-203*2
cm)
I
ord
4/5000 Agricultural 56-90 inches
(142-2-228*6
cm)
Two width range
(1)
Disc concave 'in' 52-72
ins
(132-1 -182-9
cm)
(2)
Disc concave 'out'
60-80
ins
(152-4-203-2
cm)
(1) Blocks
inside
disc
56-
80 ins
(142*2—
203-2
cm)
(2)
Blocks outside
disc
66-90
ins
(167-6-228*6
cm)
i
crease the width of the rear wheel track within one of tlm two ranges, (Figuie HW)
Loosen the adjusting screw lock nuts
(1
).
Mark the loosened nuts on the
Ford 4000 and 5000-
Move the
stop
lug
(2) to the new setting (each hole in the rail
gives a
2 inch step in track per wheel).
Select a low forward gear and hold down the right-hand
brake pedal. By
gradual application of the clutch move
the LEFT-HAND rim outwards
until the adjusting screw
(3)
strikes
the stop lug.
13