STATION PRESET BUTTONS
This feature allows you to store your
favourite stations so that they can be
recalled by selecting the appropriate
waveband and pressing one of the preset
buttons.
1. Select a waveband.
2. Tune to the station required.
3. Press and hold one of the preset
buttons. A progress bar and message
will appear. When the progress bar
completes the station has been
stored. The audio unit will also mute
momentarily as confirmation.
This can be repeated on each waveband
and for each preset button.
Whilst in radio mode, stored stations can
also be selected by pressing the arrow
up, down, right or OK buttons. Then scroll
to the desired preset station and press
OK.
Note:
When you drive to another part of
the country, FM stations that broadcast
on alternative frequencies, and are stored
on preset buttons, may be updated with
the correct frequency for that area.
AUTOSTORE CONTROL
Note:
This will store up to a maximum of
the 10 strongest signals available, either
from the AM or the FM waveband, and
overwrite the previously stored stations.
It can also be used to store stations
manually in the same way as other
wavebands.
Note:
On type 3 you must select either
FM AST or AM AST to use this function.
•
Press and hold function button 1 or
the RADIO button.
•
When the search is complete, sound
is restored and the strongest signals
are stored on the Autostore presets.
TRAFFIC INFORMATION
CONTROL
Many stations that broadcast on the FM
waveband have a TP code to signify that
they carry traffic programme information.
Activating traffic
announcements
Before you can receive traffic
announcements, you must press either
the TA or TRAFFIC button. A ‘TA’ display
will appear to show the feature is switched
on.
If you are already tuned to a station that
broadcasts traffic information, ‘TP’ will also
be displayed. Otherwise the unit will
search for a traffic programme.
When traffic information is broadcast, it
will automatically interrupt normal radio or
CD playback and ‘Traffic announcement
(TA)’ will appear in the display.
If a non-traffic station is selected or
recalled using a preset button, the audio
unit will remain on that station unless:
•
TA or TRAFFIC is turned off, then on
again.
•
On certain models, the volume control
is set to zero for four minutes after
which the audio unit will retune to
another traffic station.
Traffic announcement volume
Traffic announcements interrupt normal
broadcasts at a preset minimum level that
is usually louder than normal listening
volumes.
245
Audio unit operation
To Next Page
Loading...
Need help?
General
