5. Disconnect the electrical connector.
Note:
When fitting the headlamp, make
sure that you reconnect the electrical
connector properly.
Note:
When fitting the headlamp, make
sure that you fully engage the headlamp
in the lower fixing point.
Note:
When fitting the headlamp, make
sure that the screw is located in the
headlamp moulding before you install it.
CHANGING A BULB
WARNINGS
Switch the lights and the ignition off.
Let the bulb cool down before
removing it.
Have Xenon bulbs changed by a
properly trained technician. There is
a risk of electric shock.
CAUTIONS
Do not touch the glass of the bulb.
CAUTIONS
Only fit bulbs of the correct
specification. See Bulb
specification chart (page 69).
Note:
The following instructions describe
how to remove the bulbs. Fit
replacements in the reverse order unless
otherwise stated.
Headlamp
Note:
Remove the covers to gain access
to the bulbs.
To Next Page
Loading...
