The retractor for the rear centre seat belt
is located in the roof.
To fasten the seat belt:
1. Pull the belt out steadily. It may lock if
you pull it sharply or if the vehicle is on
a slope.
2. Securely attach the spring hook to the
anchor point.
3. Pull the tongue across the lap and
insert it into the buckle to the right of
the centre seat.
Note:
If in constant use, you can leave
the belt attached to the anchor point.
When it is not in use, or when you fold or
move the rear seats, you should release
the spring hook from the anchor point.
Press the red button on the right buckle
to release the belt. Let it retract.
Unclip the spring hook to release the belt.
Let it retract completely and smoothly to
the retractor in the roof.
Stow the tongue securely flat against the
roof trim.
WARNING
Always replace the rubber cover
when stowing the belt assembly.
31
Occupant protection
To Next Page
Loading...
Need help?
General
