30
Vehicle information systems
Saving the settings (If equipped)
Note: The settings will remain set for
one ignition cycle only. When the
ignition is switched off and back on,
the settings for the steering will return
to standard.
The settings can be permanently saved
to an ignition key. Once saved to the
key, these individual settings will be
selected automatically when this key is
inserted into the ignition. Up to four
keys can be programmed with
individual settings.
If the settings are changed in any of
the Vehicle Setup menus, SAVE
SETTINGS TO CURRENT KEY
will appear in the display before you
exit the menu.
SAVE SETTINGS TO
CURRENT KEY
ALL SAVED TO
CURRENT KEY
If you wish to save the current settings
to the key in the ignition, press the
SET/RESET button when this display
appears. ALL SAVED TO
CURRENT KEY appears in the
display to confirm that the settings
have been saved t o the key.
If you do not wish to save the
settings, but to use them for one
ignition cycle only:
•
continue scrolling to the EXIT
display and exit the menu, or
•
drive off directly. The Message
Centre will return to the
odometer/trip meter display
automatically.
To Next Page
