192
[MC12800(ALL)04/96]
Use only MERCONH power steering fluid that meets Ford’s
Specification or an equivalent.
%
*
[MC12900(ALL)01/96] Automatic Transaxle Fluid
*
[MC13000(ALL)02/96]
Under normal circumstances, you do not need to check the fluid
level of the transaxle, since your vehicle does not use up
transaxle fluid. Refer to the Maintenance Schedule booklet for
replacement intervals. However, if the transaxle is not working
properly — for instance, the transaxle may slip or shift slowly,
or you may notice some sign of fluid leakage — the fluid level
should be checked.
%
*
[MC13100(ALL)01/96
]
Checking the Automatic Transaxle Fluid
*
[MC13200(ALL)12/95]
With the vehicle on a level surface and the brake fully applied,
start the engine and move the gear shift selector through all of
the gears allowing sufficient time for each position to engage.
Securely latch the gear shift selector in the P (Park) position.
Fully set the parking brake and leave the engine running.
*
[MC13300(ALL)12/95]
Wipe off the dipstick cap and pull the dipstick out. Wipe the
indicator end clean. Put the dipstick back into the filler tube and
make sure it is fully seated. Pull the dipstick out and read the
fluid level.
*
[MC13400(ALL)12/95]
NOTE: Your vehicle should not be driven until some fluid
has been added if the fluid level is below the bottom
dimple on the dipstick and the outside temperature is
above 50˚F (10˚C). Add only enough fluid to bring the
level above the bottom hole.
*
[MC13500(ALL)12/95]
If the vehicle has not been driven and the fluid level is above
the bottom dimple on the dipstick, do not add fluid. Recheck
the fluid level after your vehicle has reached normal operating
temperature.
File:11cdmcz.ex
Update:Wed May 22 12:13:37 1996
To Next Page
Loading...
Need help?
General
