Electronic Sound Systems
25
%
*
[AS02100(ALL)03/96]
How to tune radio stations
*
[AS02200(ALL)10/95]
There are four ways for you to tune in a particular station. You
can manually locate the station using the “SCAN/TUNE”
button, “SEEK” the station, “SCAN” to the station or select the
station by using the memory buttons, which you can set to any
desired frequency. These four methods are described below.
*
[AS02300(ALL)10/95]
■ Using the “SCAN/TUNE” button to manually tune
*
[AS02400(ALL)02/96]
You can change the frequency up or down one increment at
a time (FM changes in increments of 200kHz; AM changes in
increments of 10kHz) by first pressing the “SCAN/TUNE”
button twice (display shows “TUNE”), then — within
approximately five seconds —pressing and releasing either
the top (
a
) or bottom (
b
) half of the “SEEK” button. To
change frequencies quickly, press and hold down either the
top or bottom half of the “SEEK” button. While you are
manually tuning, the display will show a blinking “M”.
*
[AS02500(ALL)03/96]
Manual tuning adjusts your radio to any allowable broadcast
frequency, whether or not a station is present on that
frequency. (See All About Radio Frequencies in this section.)
*
[AS02600(ALL)04/96]
■ Using the “SEEK” function
*
[AS02700(ALL)02/96]
This feature on your radio allows you to automatically select
listenable stations up or down the frequency band. Press the
top (
a
) half of the “SEEK” button to select the next
listenable station up the frequency band. Press the bottom
(
b
) half of the button to select the next listenable station
down the frequency band. By pressing and holding the
button, listenable stations can be passed over to reach the
desired station.
File:04cdasz.ex
Update:Fri May 24 08:25:06 1996
To Next Page
Loading...
Need help?
General
