Ford Transit 2014 - Engine Oil Dipstick; Engine Oil Check

Engine oil filler cap. See Engine Oil Check (page 142).D
Brake and clutch fluid reservoir (left-hand drive). See Brake and Clutch Fluid
Check (page 143).
E
Engine coolant reservoir. See Engine Coolant Check (page 143).F
Power steering fluid reservoir. See Power Steering Fluid Check (page 144).G
Battery positive connection (for connecting booster cables). See Jump Starting
the Vehicle (page 126).
H
Engine compartment fuse box. See Fuses (page 128).I
*
The filler caps and the engine oil dipstick are colored for easy identification.
ENGINE OIL DIPSTICK
E90983
A
B
MinimumA
MaximumB
ENGINE OIL CHECK
1. Make sure that your vehicle is on level
ground.
2. Check the oil level before starting the
engine, or switch the engine off and
wait 10 minutes for the oil to drain into
the oil pan.
3. Remove the dipstick and wipe it with
a clean, lint free cloth. Replace the
dipstick and remove it again to check
the oil level.
If the oil level is at the minimum mark, add
oil immediately.
Note: Make sure that the oil level is
between the minimum and the maximum
marks.
Note: Do not use oil additives or other
engine treatments. Under certain conditions
they may cause engine damage.
Note: The oil consumption of new engines
reaches its normal level after approximately
5,000 km.
Adding Engine Oil
WARNINGS
Only add oil when the engine is cold.
If the engine is hot, wait 10 minutes
for the engine to cool down.
Do not remove the filler cap when
the engine is running.
1. Remove the engine oil filler cap.
2. Add engine oil that meets Ford
specifications.
3. Replace the engine oil filler cap. Turn
it until you feel a strong resistance.
Note: Do not add oil further than the
maximum mark. Oil levels above the
maximum mark may cause engine damage.
Note: Soak up any spillage with an
absorbent cloth immediately.
142
Transit (TTG) Vehicles Built From: 05-07-2014, Australia, EK3J-19A321-BDA (CG3612enAUS) enAUS, Edition date: 06/2014, First Printing
Maintenance