Ford Windstar 2000 - The Wipers Are Inoperative - Rear Wipers

PINPOINT TEST C: THE WIPERS ARE INOPERATIVE — REAR WIPERS
REPAIR circuit 28 (BK/PK). REPEAT the FEM self-test, CLEAR the DTCs.
No
GO to B22.
B22 CHECK WIPER MOTOR GROUND CIRCUIT 1205 (BK) FOR OPEN
Measure the resistance between windshield wiper motor C113 Pin 3, Circuit 1205 (BK), harness side and ground.
 Is the resistance less than 5 ohms?
Yes
GO to B23.
No
REPAIR Circuit 1205 (BK). REPEAT the FEM self-test. CLEAR the DTCs.
B23 CHECK CIRCUIT 640 (RD/YE) FOR SHORT TO VOLTAGE
FEM C346
Measure the voltage between FEM C346 Pin 3, Circuit 640 (RD/YE), harness side and ground.
 Is any voltage indicated?
Yes
REPAIR Circuit 640 (RD/YE). REPEAT the FEM self-test, CLEAR the DTCs.
No
INSTALL a new windshield wiper motor. For additional information, REFER to Motor — Windshield Wiper.
REPEAT the FEM self-test, CLEAR the DTCs.
CONDITIONS DETAILS/RESULTS/ACTIONS
C1 USE THE RECORDED DTCS FROM THE FEM SELF-TEST
Use the recorded results from FEM self-test.
 Are any DTCs recorded?
Yes
If DTC B1244, GO to C2 .
If DTC B1245, GO to C5 .
If DTC B1611, GO to C7 .
No
GO to C9.
C2 CHECK THE REAR WIPER RELAY
Rear Wiper Relay
Check the rear wiper relay for correct operation. Refer to Wiring Diagram Cell 149.
 Is the rear wiper relay OK?
Page
12
of
30
2000 Windstar Workshop Manual
4/1/2010
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSYW/~MUS~LEN/21/S
...