Ford Windstar 2000 - The Washer Pump Is Inoperative - Front and Rear

PINPOINT TEST F: THE WASHER PUMP IS INOPERATIVE — FRONT AND REAR
 Is any voltage indicated?
Yes
REPAIR Circuit 640 (RD/YE). REPEAT the FEM self-test, CLEAR the DTCs.
No
INSTALL a new FEM. For additional information, REFER to Section 419-10. REPEAT the FEM self-test, CLEAR
the DTCs.
CONDITIONS DETAILS/RESULTS/ACTIONS
F1 USE THE RECORDED RESULTS FROM THE FEM SELF-TEST
Use the recorded results from the FEM self-test.
 Are any DTCs recorded?
Yes
If B1241, GO to F2 .
If B1460, GO to F3 .
No
If the front washer is inoperative, GO to F4 .
If the rear washer is inoperative, GO to F8 .
F2 CHECK CIRCUIT 1333 (LB/WH) FOR SHORT TO VOLTAGE
FEM C191
Measure the voltage between FEM C191 Pin 5, Circuit 1333 (LB/WH), harness side and ground.
 Is any voltage indicated?
Yes
REPAIR Circuit 1333 (LB/WH). REPEAT the FEM self-test, CLEAR the DTCs.
No
INSTALL a new FEM. For additional information, REFER to Section 419-10. REPEAT the FEM self-test, CLEAR
the DTCs.
F3 CHECK CIRCUIT 1321 (TN/BK) FOR SHORT TO VOLTAGE
Measure the voltage between FEM C191 Pin 14, Circuit 1321 (TN/BK), harness side and ground.
 Is any voltage indicated?
Page
20
of
30
2000 Windstar Workshop Manual
4/1/2010
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSYW/~MUS~LEN/21/S
...