Ford Windstar 2000 - The Wipers Are Inoperable - Front Wipers

PINPOINT TEST B: THE WIPERS ARE INOPERATIVE — FRONT WIPERS
C192 13 1205 (BK)
C192 14 1205 (BK)
C192 15 1205 (BK)
 Is the resistance less than 5 ohms?
Yes
REFER to Section 418-00. REPEAT the FEM self-test, CLEAR the DTCs. If still unable to communicate with the
module, INSTALL a new FEM. For additional information, REFER to Section 419-10
No
REPAIR Circuit 1205 (BK). REPEAT the FEM self-test, CLEAR the DTCs.
CONDITIONS DETAILS/RESULTS/ACTIONS
B1 USE THE RECORDED RESULTS FROM THE FEM SELF-TEST
Use the recorded results from the FEM self-test.
 Are any DTCs recorded?
Yes
If DTC B1431, GO to B2 .
If DTC B1432, GO to B4 .
If DTC B1438, GO to B6 .
If DTC B1450, GO to B9 .
No
GO to B12.
B2 CHECK THE WIPER ON/OFF RELAY — USE THE FEM ACTIVE COMAND WIPER RLY
Access the FEM active command WIPER RLY.
Windshield Wiper ON/OFF Relay
Trigger the FEM active command WIPER RLY to ON.
Measure the resistance between windshield wiper ON/OFF relay Pin 2, Circuit 1318 (DG/WH), harness side and
ground.
 Is the resistance less than 5 ohms?
Yes
INSTALL a new windshield wiper ON/OFF relay. REPEAT the FEM self-test, CLEAR the DTCs.
No
GO to B3.
B3 CHECK CIRCUIT 1318 (DG/WH) FOR OPEN
FEM C191
Page
6
of
30
2000 Windstar Workshop Manual
4/1/2010
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSYW/~MUS~LEN/21/S
...