What causes my Forney Easy Weld 140FC-i gun nozzle to arc to the work surface?
The gun nozzle arcing to the work surface is caused by slag build-up inside the nozzle or the nozzle being clogged. Clean or replace the nozzle as needed.
What causes the weld deposit to be 'stringy' and incomplete on my Forney Easy Weld 140FC-i Welding System?
A 'stringy' and incomplete weld deposit is caused by moving the gun over the workpiece too quickly. Move the gun slower.
What causes the weld deposit to be too thick on my Forney Easy Weld 140FC-i?
A weld deposit that is too thick can be caused by moving the gun over the workpiece too slowly, so move the gun faster. It can also be caused by welding voltage/amperage that is too low, so increase the welding voltage/amperage.
General| Type | MIG Welder |
|---|---|
| Input Voltage | 120V |
| Output Amperage | 140A |
| Amperage Range | 30-140A |
| Output Current Range | 30-140A |
| Gasless Operation | Yes |
| Processes | Flux-Cored |
| Duty Cycle | 30% at 90A |
| Welding Thickness | Up to 1/4 inch |
| Wire Size Range | 0.030 in - 0.035 in |
Lists key safety standards for welding and cutting operations.
Instructions for safely connecting the welder to the power supply.
Identifies and explains the various components and controls on the welder.
Step-by-step instructions for loading wire spools and feeding wire.
Provides parameter settings and tips for flux-cored wire welding.
Table addressing issues like wire feed, arc, and electrical problems.
To Next Page
