Installation 8 FortiFone™ QuickStart Guide
Wall Mounting
Wall mount the phone using the instructions below.
• Mark and drill two 7 mm (5/16”) holes for plastic wall anchors (not
included) with a vertical separation of 10 cm (4”).
• Insert two anchors into the holes, then insert and tighten two screws
(not included) leaving about 2.5 mm (1/8”) exposed.
• Attach all wiring to the phone.
• Slide the phone over the screws and ensure the phone is secure. It may
be necessary to remove the phone and tighten or loosen the screws for
secure mounting. The stand must not be attached to the phone when
mounting on a wall.
• Remove the handset hook from the phone as shown in the figure below
(illustration a). Reverse the hook and re-install so that the hook catches
the groove in the handset receiver (illustration b).
• Complete all wiring.
Figure 4: Wall mount installation
To Next Page
Loading...
