Fortinet Fortigate 100D Install Guide

Factory defaults
FortiGate-50A/50B, FortiWiFi-50B and FortiGate-100 FortiOS 3.0 MR4 Install Guide
01-30004-0265-20070831 29
Factory default Transparent mode network configuration
In Transparent mode, the FortiGate unit has the default network configuration
listed in Table 9.
Factory default firewall configuration
FortiGate firewall policies control how all traffic is processed by the FortiGate unit.
Until firewall policies are added, no traffic can pass through the FortiGate unit.
The factory default configuration contains one firewall policies to allows all traffic
through the FortiGate unit. To allow specific traffic through the FortiGate unit, you
can add firewall policies. See the FortiGate Administration Guide for information
about adding firewall policies.
The following firewall configuration settings are included in the default firewall
configuration to make it easier to add firewall policies.
Network Settings
Default Gateway (for default route) 192.168.100.1
Interface connected to external network
(for default route)
external
Default Route
A default route consists of a default gateway and the name of
the interface connected to the external network (usually the
Internet). The default gateway directs all non-local traffic to this
interface and to the external network.
Primary DNS Server 65.39.139.53
Secondary DNS Server 65.39.139.63
Table 8: Factory default NAT/Route mode network configuration (Continued)
Table 9: Factory default Transparent mode network configuration
Administrator account User name: admin
Password: (none)
Management IP
IP: 0.0.0.0
Netmask: 0.0.0.0
DNS
Primary DNS Server: 65.39.139.53
Secondary DNS Server: 65.39.139.63
Administrative access
Internal HTTPS, Ping
External Ping
DMZ HTTPS, Ping

Fortinet Fortigate 100D Specifications

General

Brand	Fortinet
Model	Fortigate 100D
Category	Firewall
Language	English