EasyManuals Logo

Fortinet Fortigate 100D Install Guide

Fortinet Fortigate 100D
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
FortiGate Firmware Installing and using a backup firmware image
FortiGate-50A/50B, FortiWiFi-50B and FortiGate-100 FortiOS 3.0 MR4 Install Guide
01-30004-0265-20070831 79
9 Type an IP address that can be used by the FortiGate unit to connect to the FTP
server.
The IP address can be any IP address that is valid for the network the interface is
connected to. Make sure you do not enter the IP address of another device on this
network.
The following message appears:
Enter File Name [image.out]:
10 Enter the firmware image file name and press Enter.
The TFTP server uploads the firmware image file to the FortiGate unit and the
following message is displayed.
Save as Default firmware/Backup firmware/Run image without
saving:[D/B/R]
11 Type B.
The FortiGate unit saves the backup firmware image and restarts. When the
FortiGate unit restarts it is running the previously installed firmware version.

Table of Contents

Other manuals for Fortinet Fortigate 100D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fortinet Fortigate 100D and is the answer not in the manual?

Fortinet Fortigate 100D Specifications

General IconGeneral
BrandFortinet
ModelFortigate 100D
CategoryFirewall
LanguageEnglish

Related product manuals