Fortinet FortiGate 4000 - Hot Swapping Interface Modules; Hot Swapping the 10;100 out of Band Management Module

Getting started Hot swapping modules
FortiGate-4000 Installation and Configuration Guide 43
7 Slide the power supply module into the slot until the lock clicks into place.
8 Turn on the power supply.
9 Replace the locking strip.
10 Quickly toggle the chassis power supply switch to turn on the power supply module.
Hot swapping interface modules
This procedure describes how to hot swap a pass-through interface module or a
switched interface module.
For more information on these modules, see “Pass-through interface module” on
page 35 and “Switched interface module” on page 35 respectively.
1 From the rear panel of the FortiGate-4000 chassis, loosen the two mounting knots that
fasten the pass-through interface module or the switched interface module that you
want to replace. Do not remove the mounting knots.
2 Do one of the following:
• For the pass-through interface module, pull it out.
• For the switched interface module, turn its power off and then pull it out.
3 Do one of the following:
• Insert the new pass-through interface module into the chassis.
• Insert the new switched interface module into the chassis, and turn on its power.
4 Tighten the mounting knots on the pass-through interface module or the switched
interface module.
Hot swapping the 10/100 out of band management module
Follow this procedure to hot swap a 10/100 out of band management module on the
rear panel of the FortiGate-4000 chassis.
For more information, see “10/100 out of band management module” on page 34.
1 From the rear panel of the FortiGate-4000 chassis, loosen the two mounting knots that
fasten the 10/100 out of band management that you want to replace. Do not remove
the mounting knots.
2 Pull the module out.
3 Insert the new switched interface module into the chassis.
4 Tighten the mounting knots on the module.
Hot swapping the management module
Follow this procedure to hot swap a management module on the rear panel of the
FortiGate-4000 chassis.
For more information on these modules, see “Management module” on page 33.
1 Power off the management module that you want to replace.
Note: If you press the chassis power supply switch for more than four seconds, the entire
FortiGate-4000 unit turns off.