Transparent mode installation Transparent mode configuration examples
FortiGate-4000 Installation and Configuration Guide 79
Figure 25: Static route to an internal destination
General configuration steps
1 Set the unit to operate in Transparent mode.
2 Configure the Management IP address and Netmask of the FortiGate unit.
3 Configure the static route to the management computer on the internal network.
4 Configure the default route to the external network.
Management Computer
172.16.1.11
Internal Network A
Internal Network B
Internal
Router
Management IP 192.168.1.1
Internet
Upstream
Router
Gateway IP 192.168.1.2
FortiResponse
Distribution
Network (FDN)
Gateway IP
192.168.1.3
FortiGate-4000
POWER ON/OFF
LAN 1 LAN 2
PWR/KVMSTATUS
KVM/ACCESS
To Next Page
Loading...
