FortiGate-200A Administration Guide Version 2.80 MR6
FortiGate-200A Administration Guide 01-28006-0072-20041105 73
System DHCP
You can configure DHCP server or DHCP relay agent functionality on any FortiGate
interface or VLAN subinterface.
A FortiGate interface can act as either a DHCP server or as a DHCP relay agent. An
interface cannot provide both functions at the same time.
This section describes:
• Service
• Server
• Exclude range
• IP/MAC binding
• Dynamic IP
Service
Go to System > DHCP > Service to configure the DHCP service provided by each
FortiGate interface. You can configure each interface to be a DHCP relay or a DHCP
server or you can turn off DHCP services.
Figure 20: DHCP service list
Note: To configure DHCP server or DHCP relay functionality on an interface, the FortiGate unit
must be in NAT/Route mode and the interface must have a static IP address.
To Next Page
Loading...
