Appendix A: Installer Public Properties
FortiClient Endpoint Security Version 4.0 MR1 Administration Guide
60 04-40001-99556-20090626
http://docs.fortinet.com/ • Feedback
USESWUID [0..1] 1 0=FortiClient will use a unique
identifier derived from the
computer that FortiClient is
running on.
1=FortiClient will use a software
unique identifier generator
1 is the preferred option, 0 can
lead to unique identifier collisions.
Note: If making hard disk images,
the “RemoveFortiClientID” tool
before creating the image.
WFLOGALLURLS [0..1] 0 If this is set to 1 and WF is
installed, all URLs visited will be
logged
WANACCDBDIR [any valid
directory]
installatio
n
directory
The directory that the WAN
acceleration database should be
located
WANACCPROTOCOL
S
[csv list of one or
more of:
http,cif,ftp,mapi]
The protocols that should be
accelerated
WFDONTRATEIP [0..1] 0 If set to 1 and if an IP address is
browsed to (instead of a FQDN),
FortiClient will not request a rating
for that IP address from the
FortiGuard network.
Table 9: Installer public properties when installing FortiClient (Part 4 of 4).
Public property Range Default Description Comment
To Next Page
Loading...