Solution
Remove the adapter and set the display to the center of the field of vision (see section
Installing Digital Module on the Optical Device).
☐
The device does not focus
Possible cause
Incorrect setting.
Solution
Adjust the device in accordance with section Powering on and Image Setting. Check
the outer surfaces of the lens and eyepiece; where necessary, wipe them free from dust,
condensate, frost, etc. In cold weather, you can use special anti-fogging coatings (as, for
example, for corrective glasses).
☐
The digital module slides off the daylight optical device
Possible cause
The adapter insufficiently clamped.
Unsuitable insert selected.
Solution
Select a suitable insert and clamp the adapter as recommended (see the section
Installing Digital Module on the Optical Device).
☐
Cannot open the adapter clamp
Possible cause
Unsuitable insert selected.
Solution
Select a suitable insert.
Check for a gap between the lips of the adapter.
☐
Remote control does not work
To Next Page
Loading...