Foscam FI9828P - Firewall

54
Foscam Digital Technologies
Telephone: 1-800-930-0949 54
w
w
www
www
.foscam.
.foscam.
us
us
Go To Home Position: When rebooting, the camera will pa Providing Central Management Software to
manage or monitor multi-cameras n / tilt and stops at center.
Go To Preset Position: Select one preset position and save it. When rebooting, the camera will pan/ tilt and
stops at the preset position you have set.
Figure 4.74
4.8 Firewall
This section explains how to control the access permission by checking the client PC’s IP addresses. It is
composed of the following columns: Block access from these IP addresses and Only allow access from
these IP addresses.
Figure 4.75
Enable firewall, If you select Only allow access from these IP addresses and fill in 8 IP addresses at most, only
those clients whose IP addresses listed in the Only allow access from these IP addresses can access the
Network Camera. If you select Block access from these IP addresses, only those clients whose IP
addresses are in the IP list cannot access the Network Camera.
Click Save to take effect.