NVR User Manual
www.foscam.com
For detailed procedure, please refer to 3.4.3 Alarm Motion Detection.
Step5 Click Save button to take effect.
-------End
3.4.3 Alarm
Motion Detection
Follow the steps to set the motion detection parameters. In the live view mode, once a motion
detection event takes place, the NVR can analyze it and perform many actions to handle it. Enable
motion detection function can trigger certain channels to start recording, or trigger full screen
monitoring, output alarm, send Email, upload FTP, buzzer alarm and so on.
In the live view mode, there are icons at the right bottom of the screen for each channel.
The Icon indicate alarm was triggered.
The Icon indicate the IPC is recording.
You can follow the steps to schedule a record which triggered by the detected motion.
Choose (Parameter Configuration) > Alarm > Motion Detection. The Motion Detection
page is displayed.
Step1
Select channel from drop-down box list.
To Next Page
Loading...
