Transport Layer Security you select.
2-----SMTP Username / password ID account and password of the sender email address
3----- Sender E-mail Mailbox for sender must support SMTP
4----- Receiver Mailbox for receiver need not support SMTP, you can set 4 receivers
5----- Save Click Save to take effect
6----- Test Click Test to see if Mail has been successfully configured.
Click Test to see if Mail has been successfully configured.
If the test success, you can see the Success behind the Test, at the same time the receivers will receive
a test mail.
If the test fails with one of the following errors after clicking Test, verify that the information you entered is
correct and again select Test .
1) Cannot connect to the server.
2) Network Error. Please try later.
3) Server Error.
4) Incorrect user or password.
5) The sender is denied by the server. Maybe the server need to authenticate the user, please check it
and try again.
6) The receiver is denied by the server. Maybe because of the anti-spam privacy of the server.
7) The message is denied by the server. Maybe because of the anti-spam privacy of the server.
8) The server does not support the authentication mode used by the device.
3.7.4.5 FTP Settings
If you want to upload record images to your FTP server，you can set FTP Settings.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
