3G3 Cabinets - Service Manual
General Information
All installations must conform to local and municipal regulations and directives. In the case of doubt contact a Foster authorised
dealer or the Foster Technical Department. The information contained in this manual is current at the time of publication and is
subject to change without notice.
General Safety
- Do not store explosive substances such as aerosol cans with a ammable propellant in this
appliance.
- Keep all ventilation openings in the appliance or in the structure of a built in unit clear of any
obstructions.
- Do not use electrical appliances inside the storage compartment.
- Do not use steam cleaners, pressure washers or other jets/sprays of water on or around the
appliance.
- The appliance is air tight when the door is closed therefore under no circumstances should
any living body be stored or ‘locked in’ the appliance.
- This appliance is heavy. When moving the appliance care should be taken and correct safe
practices followed. The appliance should not be moved over uneven surfaces.
- The emitted sound level of this appliance is not greater than 70dB(A).
- To ensure stability the appliance should be located on a at, level surface, correctly loaded.
- Do not use mechanical devices to accelerate the defrost process.
- Care should be taken not to damage the refrigeration circuit and/or system.
- If the supply cord is damaged, it must be replaced by the manufacturer, it’s service agent or
similarly qualied persons in order to avoid hazards.
- Care should be taken to avoid prolonged contact with cold surfaces with unprotected body
parts, correct PPE to be used at all time.
Climate Class
Climate class indicated on the serial plate shows the ambient temperature & humidity at which this appliance has been tested, for the purposes of
establishing values in line with European standards.
Climate Class Temperature Relative humidity
4 30˚C 55%
5 40˚C 40%
Disposal Requirements
This appliance contains components and materials which can be harmful to the environment if
not disposed of correctly. Disposal of this appliance should be carried out by a suitably licensed
waste contractor in accordance with national laws and regulations which may be in force at the
time.
Electrical Safety
This equipment shall be connected to an electrical supply protected by a Residual Current Device
(RCD). This may include a residual current circuit breaker (RCCB) type socket, or through a Residual
Current Circuit Breaker with overload protection (RCBO) supplied circuit.
Should it be necessary to replace the fuse, the replacement fuse must be of the value stated on
the serial label for the appliance.
To Next Page
Loading...
