4 www.fosterrefrigerator.com
Locating the appliance
After unpacking, clean (cleaning directions supplied within this manual) and allow the appliance
to stand for 60 minutes before turning on.
Ensure the appliance is situated on a rm, level surface, away from both hot and cold air
sources, as this will aect its performance.
Place the appliance in a location so as not to exceed the maximum rated ambient
temperature.
The appliance produces warm air when operating normally and requires adequate
ventilation. The dimensions indicated are a minimum.
As the operating temperature has been pre-set no adjustments are required. Allow the
appliance to reach its normal operating temperature before loading with product.
Connect the appliance to a suitable power supply. Do not connect or disconnect the
appliance with wet hands. The appliance will turn on automatically displaying the actual
internal temperature of the appliance. If this does not happen and button 3 is ‘pulsing’
press and hold button 3 for 3 seconds to turn on the appliance.
100mm
50mm
50mm
To Next Page
Loading...
