42
The upper blade guide with its protection (48) is activated by
means of a knob (49), which in turn activates a rack. Turn this
knob (49) to adjust the height of the upper blade guide in the
desired position.
II. Saw blade’s lower protection
Saw blade’s lower protection (21) prevents from any unintentional contacts with the blade. This
protection must be moved when you open the lower door. When you close this door this
protection must be replaced in its position to not to compromise general safety. Saw blade’s
lower protection must be always assembled when you are using the machine.
III. Flywheels’ doors
By opening the doors (22) you can get at the flywheels-pulleys to change the blade, remove
the sawdust which has piled up, change the speed by moving the belt on the pulleys. When
using the machine, these doors are safety devices that isolate moving parts that could be
dangerous.
To open and close the doors, give the locking devices a quarter of a turn by using a suitable
flat screwdriver.
IMPORTANT:
Bandsaw’s two doors must be always closed when the machine is in use. It is forbidden
to start the machine if these two doors are open.
WARNING!
Before performing any adjustment or maintenance task and before changing the
blade you must switch off the machine, disconnect it from the power supply and wait
for the saw blade to stop.
CAUTION
Connect the bandsaw to the electrical energy and start it only after checking that
the machine is fastened, that the workbench is assembled and adjusted, that saw blade
tensioning is correct and that all safety and protection devices are perfectly efficient.
FUNCTIONING
To Next Page
Loading...
