34
3
Integrated Peripherals
► OnChip IDE Device / Onboard Device / SuperIO Device / USB Device Setting
Press <Enter> to go to relative submenu.
OnChip IDE Device
► IDE HDD Block Mode
If your IDE hard drive supports block mode, select [Enabled] for automatic detection of the
optimal number of block read/write per sector.
► IDE DMA Transfer Access
[Disabled] : to disable DMA transfers for all IDE drives. They will revert to PIO mode transfers.
[Enabled] : to enable DMA transfers for all IDE drives. The proper DMA mode will be detected
at boot-up. If the drive does not support DMA transfers, then it will use PIO mode instead.
Phoenix - AwardBIOS CMOS Setup Utility
Integrated Peripherals
► OnChip IDE Device [Press Enter] Item Help
► Onboard Device
[Press Enter]
► SuperIO Device
[Press Enter] Menu Level ►
► USB Device Setting
[Press Enter]
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F7: Optimized Defaults
Press Enter
Phoenix - AwardBIOS CMOS Setup Utility
OnChip IDE Device
IDE HDD Block Mode [Enabled] Item Help
IDE DMA Transfer Access [Enabled]
On-Chip Primary PCI IDE
[Enabled] Menu Level ►
IDE Primary Master PIO [Auto]
IDE Primary Slave PIO [Auto]
If your IDE hard drive
IDE Primary Master UDMA [Auto] supports block mode
IDE Primary Slave UDMA [Auto]
select Enabled for
automatic detection of
*** On-Chip Serial ATA Setting *** the optimal number of
On-Chip Serial ATA [Enhanced Mode] block read/writes per
SATA PORT Speed Setting [Disabled] sector the drive can
x PATA IDE Mode Primary support.
SATA Port P1,P3 is Secondary
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F7: Optimized Defaults
Enabled
To Next Page
Loading...
