Foxconn G31MX 2.0 Series - Page 45

38
3
USB Device Setting
► USB Controller
This item is used to enable or disable the Universal Host Controller Interface for USB.
► USB 2.0 Controller
This item is used to enable or disable the Enhanced Host Controller Interface for USB.
► USB Operation Mode
This item is used to set the USB operation mode. If you select the [High Speed], then the USB
operation mode is determined by the USB device; select [Full/Low Speed], the USB device
operates on full/low speed.
► USB Keyboard Function
This item is used to enable the support for USB keyboard on legacy OS. If you have a USB
keyboard, set to auto or enabled.
► USB Mouse Function
This item is used to enable the support for USB mouse on legacy OS. If you have a USB
mouse, set to auto or enabled.
► ***USB Mass Storage Device***
BIOS auto detects the presence of USB Mass Storage Devices, you can congure the Boot
setting mode for the detected USB MSD. Setting Options: [Auto]; [FDD Mode]; [HDD Mode].
Phoenix - AwardBIOS CMOS Setup Utility
USB Device Setting
USB Controller [Enabled] Item Help
USB 2.0 Controller
[Enabled]
USB Operation Mode [High Speed] Menu Level ►
USB Keyboard Function [Enabled]
USB Mouse Function [Enabled] [Enable] or [Disable]
Universal Host
Controller Interface
*** USB Mass Storage Device *** for Universal
Serial Bus
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F7: Optimized Defaults
Enabled