42
3
► Wake-Up on LAN
This item is used to set the system to wake up by LAN.
► USB KB Wake-Up from S3
This item is used to set the system to wake up by USB keyboard when it is staying at S3
(Suspend to RAM) state.
► Resume by Alarm
This item is used to set the timing of the start-up function. In order to use this function, the
start-up password function must be disabled. Also, the PC power source must not be turned
off.
► Date (of Month) Alarm
When Resume by Alarm is set to “Enabled”, this item can be modied. It is used to set the
timing for the start-up date.
► Time (hh:mm:ss) Alarm
When Resume by Alarm is set to “Enabled”, this item can be modied. It is used to set the
timing for the start-up time.
► Power On by Mouse
When enabled, it allows you to use the mouse to wake up the system from soft off and green
mode. This feature requires an ATX power supply.
► Power On by Keyboard
This item allows you to use the keyboard to wake up the system from soft off and green mode.
This feature requires an ATX power supply. The options are: [Disabled]; [Password]; [Hot
KEY]; [Any KEY], and [Keyboard 98].
► KB Power ON Password
When Power On by Keyboard is set to [Password], this item allows you to input a password to
wake up the system from soft off and green mode.
► Hot Key Power ON
When Power On by Keyboard is set to [Hot KEY], this item allows you to press a [Ctrl] +
Function key to wake up the system from soft off and green mode.
► PWRON After PWR-Fail
This item is used to set which state the PC will take with when it resumes after an AC power
loss.
To Next Page
Loading...
