105
5
2. Copy section 5-2, BIOS Conguration.
Shut down the computer, connect SATA hard disks to SATA ports, power on
computer again.
Press <Del> key, get into BIOS, set SATA mode to [RAID], press <F10> to save and
exit BIOS. PC will reboot.
3. Copy section 5-3, Create RAID in BIOS.
Press <CTRL><I> simultaneously to get into RAID BIOS set up (Intel
®
Matrix
Storage Manager option ROM utility).
Congure your new hard disks to RAID0, 1, 5 or 10. Exit RAID BIOS. PC will reboot.
4. The Windows XP is running again and a new hardware of RAID disk was found.
Click [Cancel] to skip this Wizard.
Click to exit.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
IDE Conguration
IDE Conguration Help Item
SATA Mode Select [RAID] Select SATA Work Mode
Max Ports on SATA [6 Ports]
► AHCI Configuration
[Press Enter]
Intel Matrix Storage
► Primary IDE Master
[Not Detected] Manager driver only
► Primary IDE Slave [Not Detected]
support on
► Secondary IDE Master [Not Detected]
ICH9R( P35A-S ),
► Secondary IDE Slave [Not Detected]
not ICH9. ( P35A )
So if your MB is with
IDE Detect Time Out (Sec) [35]
ICH9 chip, then you
can't enable AHCI in
Windows XP,
Windows Vista
has in-box driver.
So it's ok.
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F7:Previous Values F8:Fail-Safe Defaults F9:Optimized Defaults
[RAID]
To Next Page
Loading...
Need help?
General
