3
38
PCI/PNP Resource Management
IRQ and DMA Settings
The BIOS has the capability to automatically congure all of the boot and Plug & Play compatible
devices. Normally, you should set them as [Available], so that the BIOS can automatically assign
the IRQs and DMA channels. In the old days, you might assign each IRQ or DMA channel to a
Legacy ISA card, and you had to change the setting to [Reserved] to reserve IRQ/DMA for this
ISA card. This happened mostly on the ISA bus sound cards. Legacy ISA devices are compliant
with the original PC AT bus specication and require a specic interrupt / DMA channel to function
properly.
Now, ISA bus is disappeared on the motherboard, only PCI PnP devices are considered. PCI PnP
devices, on the other hand, adhere to the Plug & Play standard and can use any interrupt / DMA
channel. The IRQ/DMA assignments here are just to reserve some particular resources for them,
and you can go to Device Manager for the assignments.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
IRQ & DMA Settings
IRQ & DMA Settings Help Item
IRQ3 [Available] Available: Specied
IRQ4 [Available] IRQ is available to be
IRQ5 [Available] used by PCI/PnP
IRQ7 [Available] devices.
IRQ9 [Available] Reserved: Specied
IRQ10 [Available] IRQ is reserved for
IRQ11 [Available] use by Legacy ISA
IRQ14 [Available] devices.
IRQ15 [Available]
DMA Channel 0 [Available]
DMA Channel 1 [Available]
DMA Channel 3 [Available]
DMA Channel 5 [Available]
DMA Channel 6 [Available]
DMA Channel 7 [Available]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F7:Previous Values F8:Fail-Safe Defaults F9:Optimized Defaults
[Available]
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
PCI/PNP Resource Management
Advanced PCI/PnP Settings Help Item
WARNING: Setting wrong values in below sections IRQ & DMA Settings
may cause system to malfunction.
► IRQ & DMA Settings [Press Enter]
Plug & Play O/S [No]
PCI Latency Timer [64]
Allocate IRQ to PCI VGA [Yes]
Palette Snooping [Disabled]
PCI IDE BusMaster [Enabled]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F7:Previous Values F8:Fail-Safe Defaults F9:Optimized Defaults
[Press Enter]