Foxconn P55MX Series - Superio Configuration

3
32
► IDE Detect Time Out
This item is used to select the time out value for detecting ATA/ATAPI devices. If the checking
time is over the set value, the system will skip it.
OnBoard Conguration
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
OnBoard Conguration
OnBoard Audio Controller Help Item
OnBoard LAN Controller [Enabled]
OnBoard LAN Boot ROM
[Disabled]
Enabled
Disabled
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enabled]
Options
► OnBoard Audio Controller
This item is used to enable or disable the HD Audio controller.
► OnBoard LAN Controller
This item is used to enable or disable the onboard LAN controller.
► OnBoard LAN Boot ROM
This item is used to enable or disable the onboard LAN boot optional ROM. A LAN boot ROM
lets you set up a diskless workstation on the network. By installing a boot ROM in the network
board, you can enable a client PC system on the network to be booted remotely.
SuperIO Conguration
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
SuperIO Conguration
SuperIO Conguration
Help Item
OnBoard Floppy Controller
[Enabled] Allows BIOS to Enable
Serial Port1 Address [3F8/IRQ4]
or Disable Floppy
Serial Port1 Mode [Normal] Controller.
Serial Port2 Address [2F8/IRQ3]
Serial Port2 Mode [Normal]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enabled]